Operating The Attachment Lift Lever; Positioning The Seat - Toro 72211 417XT Wheel Horse Operator's Manual

2. Push the lift switch in the up direction to raise the
attachment lift (Fig. 13). This will lift and hold the
attachment in the up, or raised position.
Lowering Attachments
1. Turn key to the on or run position (Fig. 13).
2. Push the lift switch in the down direction to lower the
attachment lift (Fig. 13). This will lower the
attachment lift.
2
3
Figure 13
1. Key
2. Lift switch —up
Operating the Attachment Lift
Lever
The attachment lift lever (Fig. 14) is used to raise and
lower various attachments.
Raising an Attachment
1. Depress the clutch and brake pedals to stop the
machine.
2. Pull attachment lift lever rearward until latch locks. In
this position the lift will hold the attachment in the up,
or raised position.
Lowering an Attachment
1. Depress the clutch and brake pedals to stop the
machine.
2. Pull attachment lift lever rearward, to release lift
pressure, and push the button on top to release the
latch. Move lift lever forward to lower attachment.
1
m–6513
3. Lift switch —down
22
2
1
Figure 14
1. Lift lever

Positioning the Seat

The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Fig. 15).
2. Slide the seat to the desired position and tighten the
knobs.
1
Figure 15
1. Adjustment knob
m–6531
2. Button
m–4982