Installing The Steering Wheel; Installing The Seat - Toro 72211 417XT Wheel Horse Operator's Manual

Installing the Steering Wheel

1. Position the front wheels straight ahead.
2. Remove the logo cover by releasing the 3 latches from
the back side with a screwdriver.
3. Line up the center spoke toward the seat and position
the steering wheel onto the shaft spline (Fig. 2).
4. Secure the steering wheel with a lockwasher (1/2 inch)
and nut (1/2 inch) (Fig. 2).
5. Torque the steering wheel nut to 50 ft-lb (37 N
6. Snap the logo cover into place (Fig. 2).
5
4
Figure 2
1. Center spoke
2. Shaft spline
3. Lock washer, 1/2 inch

Installing the Seat

1. Install the large inside diameter spacer and the 2
shoulder bolts into the rear holes of the seat (Fig. 3).
2. Position the seat onto the seat base by inserting the
2 shoulder bolts through the key hole openings at the
end of both slots (Fig. 3).
3. Locate the small inside diameter spacer between the
seat and the seat base, thread the 2 knobs and 2 flat
washers (11/32 inch) into the front holes in the seat
(Fig. 3). Adjust the seat and tighten the knobs.
4. Route the seat switch wire and connector through the
center opening in the seat base. Push the seat switch
connector fully into the wire harness connector (Fig.
3).
5. Secure the seat switch wire cable to the fender opening
(Fig. 3).
.
m).
1
3
2
2307
4. Nut, 1/2 inch
5. Logo cover
13
1
6
2
9
5
7
Figure 3
1. Seat
2. Spacer-small ID
3. Spacer-large ID
4. Shoulder bolt
5. Knob
3
4
8
m–5081
6. Wire and connector
7. Wire harness connector
8. Wire clip
9. Flat washer, 11/32 inch