Using The Attachment Power Lift; Operating The Attachment Lift Lever; Adjusting The Height Of Cut - Toro 78291 Operator's Manual

Disengaging the Power Take Off (PTO)
1. Push the power take off (PTO) to the off position
(Fig. 19).
Using the Attachment Power
Lift
The attachment power lift (Fig. 20) is used to raise and
lower attachments.
Raising Attachments
1. Turn key to the on or run position (Fig. 20).
2. Push the lift switch in the up direction to raise the
attachment lift (Fig. 20). This will lift and hold the
attachment in the up, or raised position.
Lowering Attachments
1. Turn key to the on or run position (Fig. 20).
2. Push the lift switch in the down direction to lower the
attachment lift (Fig. 20). This will lower the attachment
lift.
2
3
Figure 20
1. Key
2. Lift switch —up
1
m–6513
3. Lift switch —down
10
Operating the Attachment Lift
Lever
The attachment lift lever (Fig. 21) is used to raise and lower
various attachments.
Raising an Attachment
1. Depress the brake pedal to stop the machine.
2. Pull the attachment lift lever rearward until the latch
locks. In this position the lift will hold the attachment in
the up, or raised position.
Lowering an Attachment
1. Depress the brake pedal to stop the machine.
2. Pull the attachment lift lever rearward, to release the lift
pressure, and push the button on top to release the latch.
Move the lift lever forward to lower the attachment.
2
1
Figure 21
1. Lift lever

Adjusting the Height of Cut

The rear support wheels adjust for different heights of cut,
between 1-1/2 and 4-1/2 inch (4 to 11 cm).
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
m–6531
2. Button