Controls For Model 419Xt; Operating The Parking Brake; Starting And Stopping The Engine - Toro 72211 417XT Wheel Horse Operator's Manual

Controls for Model 419XT

Become familiar with all the controls (Fig. 2) before you
start the engine and operate the machine.
13
10
11
7
12
8
Figure 2
1. Steering wheel
2. Ignition switch
3. Brake pedal
4. Parking brake lever
5. Ground speed selector
6. Throttle lever
7. Choke lever

Operating the Parking Brake

Always set the parking brake when you stop the machine
or leave it unattended.
Setting the Parking Brake
1. Push the brake pedal (Fig. 3) down and hold it in the
depressed position.
2. Push the parking brake lever (Fig. 3) forward and
gradually take your foot off the brake pedal. The brake
pedal should stay in the depressed (locked) position.
1
6
9
2
3
5
4
m–6513
8. Power take off (PTO)
9. Cruise control switch
10. Indicator control
module/Hourmeter
11. Attachment lift switch
12. Tilt wheel lever
13. Hood opening
17
Releasing the Parking Brake
1. Push down on the brake pedal (Fig. 3). The parking
brake lever should release.
2. Gradually release the brake pedal.
Figure 3
1. Brake pedal
Starting and Stopping the
Engine
Starting the Engine
1. Sit down on the seat.
2. Set the parking brake; refer to Setting the Parking
Brake, page 17.
Note: The engine will not start unless you set the parking
brake or fully depress the brake pedal.
3. Push the PTO (power take off) to the off position
(Fig. 4).
4. Move the choke lever to the on position (Fig. 4).
Note: An engine that has been running and is warm may
not require step 4.
5. Move throttle lever to the fast position (Fig. 4).
6. Turn the ignition key and hold it in the start position
(Fig. 5). When the engine starts, release the key.
Important
If the engine does not start after 10 seconds
of continuous cranking, turn the ignition key to off and let
the starter motor cool for 60 seconds; refer to
Troubleshooting, page 39.
1
2
m–6516
2. Parking brake lever