Headlights; Positioning The Tilt Steering Wheel; Using The Cruise Control - Toro 72211 417XT Wheel Horse Operator's Manual

Headlights

The headlights are turned on with a separate position,
lights, of the ignition switch (Fig. 16). The lights are on
while the ignition switch is in the lights position even with
the engine off. Remove the key when the machine is left
unattended so lights can not be turned or discharging the
battery.
Figure 16
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 17).
2. Move the steering wheel to a comfortable position;
then release the lever to lock.
1
Figure 17
1. Tilt lever
1
1208
2
1203b
2. Steering wheel
23

Using the Cruise Control

A three position switch, located on the dash (Fig.18), with
the functions of: Lock–Set (spring loaded), On and
Unlock–Off controls the engagement. Cruise control
maintains the traction control position without foot
pressure. Cruise control is intended for operation in the
forward direction only. Do not use cruise control in
reverse.
Engaging the Cruise Control
1. Begin driving tractor: Refer to Driving Forward or
Backward, page 21. While holding your foot steady on
the traction control, push the cruise control switch
(Fig. 18) to the lock–set position.
Figure 18
1. Lock–Set
2. This locks the traction control in position and your
foot can then be removed from the traction control.
A constant ground speed will be maintained.
Disengaging the Cruise Control
1. While holding your foot steady on the traction control,
move the cruise control switch (Fig. 18) to the
unlock–off position.
2. This unlocks the traction control and your foot then
operates the traction control.
3. For quick stops, just press on the brake pedal. This
automatically disengages the cruise control and applies
the brake at the same time.
1
2
1238
2. Unlock–Off