Stopping The Machine; Operating The Attachment Lift Lever; Positioning The Seat - Toro 72200 Operator's Manual

Note: For reverse motion, with the PTO engaged, the
operating-in-reverse interlock must be deactivated by the
KeyChoice switch located on the seat bracket on the right
hand side just below the seat.
To slow down, release the pressure on the traction control
pedal.
Important To avoid transmission damage, always
release the parking brake before moving the traction
control pedal.
Figure 9
1. Forward

Stopping the Machine

To stop the machine, release the traction control pedal,
disengage the power take off (PTO), and turn the ignition
key to off. Also set the parking brake if you leave the
machine unattended; refer to Setting the Parking Brake,
page 15. Remember to remove the key from the ignition
switch.
Caution
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition and KeyChoice keys
and set the parking brake when leaving the
machine unattended, even if just for a few
minutes.
Operating the Attachment Lift
Lever
The attachment lift lever (Fig. 10) is used to raise and
lower various attachments.
1
2
1210
2. Backward
19
Raising an Attachment
1. Pull attachment lift lever rearward until latch locks. In
this position the lift will hold the attachment in the up,
or raised position.
Lowering an Attachment
1. Pull attachment lift lever rearward, to release lift
pressure, and push the button on top to release the
latch. Move lift lever forward to lower attachment.
2
1
Figure 10
1. Lift lever

Positioning the Seat

The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Fig. 11).
2. Slide the seat to the desired position and tighten the
knobs.
1
Figure 11
1. Adjustment knob
m–6531
2. Button
m–4982