Setup; Installing The Steering Wheel (Tc And H Models Only) - Toro 07390 Workman HDX-Auto Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Parts Manual
Operator Training Material
CVT Kit 121-9853
CVT Adapter 127-8750
Note: Determine the left and right side of the machine from the normal operating position.
1
Installing the Steering Wheel
(TC and H Models only)
Parts needed for this procedure:
1 Steering wheel
1 Cover
1 Washer (5/8 inch)
Procedure
1. If the cover is installed, remove the it from the hub of
the steering wheel (Figure
2. Remove the nut from the steering shaft
3. Slide the steering wheel and washer onto the steering
shaft (Figure 3).
Description
Steering wheel
Cover
Washer (5/8 inch)
ROPS frame
Flange-head bolt (1/2 x 1-1/4 inch)
No parts required
No parts required
No parts required
3).
(Figure
Qty.
1
1
1
1
6
–
–
–
Qty.
1 Read before operating the vehicle.
1 Use to reference part numbers.
1 View before operating the machine.
1 Connecting the CVT Intake Duct (TC and H Models Only)
1 Connecting the CVT Intake Duct (TC and H Models Only)
4. Secure the steering wheel to the shaft with the nut and
tighten it to 27–34 N-m (20-25 ft-lb).
5. Install the cover on the steering wheel
3).
12
Use
Install the steering wheel.
Mount the ROPS (Rollover Protection
System).
Connect the battery.
Connect the continuously variable
transmission intake duct.
Check the engine oil, transaxle/hydraulic
fluid, coolant, and brake fluid levels.
Use
(Figure 3).