Toro 07390 Workman HDX-Auto Operator's Manual page 48

5. Remove the drain plug from the drain port by rotating
the plug counterclockwise and removing it from the
transmission (Figure
Note: Allow the transmission fluid to drain completely.
6. Install the drain plug
7. Add 700 ml (23.7 oz) of Dexron VI transmission fluid
into the transmission through the fill port
Note: Use a funnel with a flexible hose when filling
the transmission.
Note: When the transmission fluid level is correct, the
fluid should be level with the bottom of the threads
in the fill port.
8. Install the fill plug
Servicing the Reservoir of the
Speed-control Cylinder
Service Interval: Every 200 hours
Reservoir Fluid Type: DOT 3 brake fluid
1. Remove the knobs from the hydraulic-lift lever and the
speed-range lever (Figure
1. Knob (speed-range lever)
2. Rod (speed-range lever)
3. Knob (hydraulic-lift lever)
2. Remove the 6 hex-washer screws (#10 x 3/4 inch) that
secure the control-cover plate to the seat base, and
remove the cover plate
3. Move the speed-range lever to the transport position;
refer to Using the Speed-range Control (page
4. Check the fluid level in the reservoir for the speed
control cylinder (Figure
Note: The normal fluid level is between the Min and
Max marks on the side of the reservoir.
69).
(Figure 69).
(Figure
(Figure 68).
70).
Figure 70
4. Rod (hydraulic-lift lever)
5. Control-cover plate
6. Hex-washer screws (#10
x 3/4 inch
(Figure 70).
71).
68).
1. Cap
2. Max mark (reservoir)
5. If the fluid level is low, perform the following:
A. Wipe clean the area around the cap for the
reservoir
B. Remove the cap from the reservoir
C.
between the Min and Max marks on the side of
the reservoir
D. Install the cap hand tight
6. Align the holes in the control-cover plate to the holes
in the seat base
7. Secure the plate to the base with the 6 hex-washer
screws
8. Thread the knobs onto the rods for the hydraulic-lift
lever and the speed-range lever
Adjusting the Speed Control
Important: The minimum controlled speed for the
machine is 4.0 kph (2.5 mph) at full engine speed.
Controlling the machine speed slower that 4.0 kph (2.5
mph) will result in excessive belt and clutch wear.
1. Drive the machine in speed range A (low range), B
(mid-low range), C (mid-high range), or D (high range)
in order to determine which speed range includes the
maximum-ground speed that you want to set; refer to .
Note: Use the speedometer to determine the speed
27).
that the machine is traveling.
2. Remove the knobs from the hydraulic-lift lever and the
speed-range lever
3. Remove the 6 hex-washer screws (#10 x 3/4 inch) that
secure the control-cover plate to the seat base, and
remove the cover plate
4. Move the speed-range lever to the T (transport)
position
48
Figure 71
3. Min mark (reservoir)
4. DOT 3 brake fluid
(Figure 71).
Add the specified fluid to raise the level midway
(Figure 71).
(Figure
(Figure 70).
(Figure 70) that you removed in step 2.
(Figure 70).
(Figure
(Figure 72).
(Figure 71).
71).
(Figure 70).
70).