Toro 07390 Workman HDX-Auto Operator's Manual page 18

1. Engine speed (in rpm)
Hour Meter
The hour meter indicates the total hours of machine
operation. The hour meter
whenever the key switch is rotated to the On position or if
the engine is running.
Speedometer
The speedometer registers the ground speed of the vehicle
(Figure 14). The speedometer is in mph, but you can easily
converted the speedometer to km/h. Refer to
the Speedometer (page 54).
Check Engine Light
The check engine light (Figure
operator of a engine malfunction.
Contact your authorized Toro service dealer.
Oil Pressure Warning Light
The oil pressure warning light illuminates
engine oil pressure drops below a safe level while the engine
is running.
Important: If the light flickers or remains on, stop the
vehicle, turn off the engine, and check the oil level. If the
oil level was low, but adding oil does not cause the light
to go out when the engine is started, turn the engine
off immediately and contact your Authorized Service
Distributor for assistance.
Coolant Temperature Gauge and Light
The coolant temperature gauge displays the coolant
temperature of the engine. The light operates only when the
ignition switch is in On position
Figure 15
2. 3300 rpm for 540 rpm PTO
operation
(Figure 14) starts to function
Converting
14) will illuminate to notify
(Figure 14) if the
(Figure 14). The coolant
temperature light will illuminate red and flash if the engine
overheats.
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank. It
displays only when ignition switch is in the On position
(Figure 14). The red segment of the display indicates low
fuel level and the flashing-red light indicates that the fuel in
the tank is near empty.
Passenger Hand Hold
The passenger hand hold is located on the dashboard
16).
1. Passenger hand hold
Seat Adjusting Lever
Use the seat adjustment lever to adjust the seat forward or
backward for operator comfort
1. Seat-adjusting lever
18
Figure 16
2. Storage compartment
(Figure 17).
Figure 17
(Figure