Checking The Fluid Levels; Product Overview; Controls - Toro 07390 Workman HDX-Auto Operator's Manual

4. Remove the bed support, lower the bed, shut off the
engine, and remove the key from the ignition switch.
5

Checking the Fluid Levels

No Parts Required
Procedure
1. Check the engine oil level before and after the engine is
first operated; refer to
(page 21).
2. Check the transmission-fluid level before the engine is
first operated; refer to
Level (page 47).
3. Check the engine-coolant level before the engine is first
operated; refer to (page
4. Check the brake fluid level before the engine is first
operated; refer to Checking the Brake Fluid (page
Checking the Engine-oil Level
Checking the Transmission-fluid
).

Product Overview

Controls

Note: Determine the left and right sides of the machine
from the normal operating position.
Accelerator Pedal
The accelerator pedal
to vary the engine and ground speed of the vehicle when the
transmission is in gear. Pressing the pedal increases the engine
speed and ground speed. Releasing the pedal decreases the
engine speed and ground speed of the machine.
24).
1. Brake pedal
Brake Pedal
Use the brake pedal
to stop or slow the machine.
CAUTION
Brakes that are worn or not correctly adjusted may
result in personal injury. If the brake pedal travels
to within 3.8 cm (1-1/2 inches) of the machine floor
board, adjust or repair the brakes.
Transmission Lever
Use the transmission lever
between P (park), R (reverse), N (neutral), L (low forward),
and D (drive) ground operation.
Important: Do not shift the transmission to the Reverse,
Low, or Drive gear unless the vehicle is standing still and
the engine is at low idle. Otherwise you may damage
the transmission.
15
(Figure 8) gives the operator the ability
Figure 8
2. Accelerator pedal
(Figure 8) to apply the service brakes
(Figure 9) to shift the transmission