Using The Bed Safety Support; Removing The Full Bed - Toro 07390 Workman HDX-Auto Operator's Manual

Using the Bed Safety Support

Important: Always install or remove the bed support
from the outside of the bed.
1. Raise the bed until the lift cylinders are fully extended.
2. Remove the bed support from the storage brackets on
back of the ROPS panel
1. Bed support
3. Push the bed support onto the cylinder rod, making
sure that the support end tabs rest on the end of
cylinder barrel and on the cylinder rod end
1. Bed support
2. Cylinder barrel
4. When finished, remove the bed support from the
cylinder and insert it into the brackets on the back of
the ROPS panel.
Important: Do not try to lower bed with bed
safety support on cylinder.
(Figure 40).
Figure 40
(Figure
Figure 41
3. Bed

Removing the Full Bed

Full bed weight: approximately 147.5 kg (325 lb)
1. Start the engine.
2. Move the hydraulic lift lever forward and lower the
bed until the cylinder rod ends are loose in the slots (
Hydraulic Lift Lever (page
3. Release the lift lever and turn off the engine.
4. Remove the lynch pins from the outer ends of the
cylinder rod clevis pins
41).
1. Cylinder rod end
2. Bed mounting plate
3. Clevis pin
5. Remove the clevis pins securing the cylinder rod ends
to the bed mounting plates by pushing the pins toward
the inside (Figure
6. Remove the lynch pins and clevis pins securing the
pivot brackets to the frame channels
7. Lift the bed off the machine.
Important: The full bed weighs approximately
147.5 kg (325 lb), so do not try to install or remove
it by yourself. Use an overhead hoist or get the
help of 2 or 3 other people.
8. Store the cylinders in the storage clips.
9. Set the hydraulic lift lock lever on the machine to the
Lock position; refer to .
Note: Lock the lever to prevent the lift cylinders from
extending.
36
16)).
(Figure 42).
Figure 42
4. Lynch pin
5. Rear slot (Full bed)
6. Front slot (2/3 bed)
42).
(Figure 42).