Toro 07390 Workman HDX-Auto Operator's Manual page 49

5. Loosen the 2 hex-socket screws (5/16 x 3/4 inch) that
secure the detent plate to the lever-support bracket
(Figure 72).
Figure 72
1. Lever-support bracket
2. Hex-socket screws
6. Move the detent plate in one of the following directions:
•
Move the detent plate forward to increase the
maximum ground speed limit
•
Move the detent plate rearward to decrease the
maximum ground speed limit
7. Tighten the 2 hex-socket screws (5/16 x 3/4 inch) to
1978 to 2542 N-cm (175 to 225 in-lb).
8. Drive the machine with the speed control set to speed
range for which you are setting the maximum ground
speed limit. If the maximum ground speed limit is too
fast or too slow, repeat steps
correct maximum ground speed limit is attained.
9. Align the holes in the control-cover plate to the holes
in the seat base (Figure
10. Secure the plate to the base with the 6 hex-washer
screws (Figure 70) that you removed in step 3.
11. Thread the knobs onto the rods for the hydraulic-lift
lever and the speed-range lever
3. Detent plate
(Figure 72).
(Figure 72).
1 through 8 until the
70).
(Figure 70).
Checking the Drive Belt
Service Interval: Every 400 hours
1. Remove the 9 hex-washer bolts (1/4 x 1 inch) that
secure the transmission cover to the mounting plate of
the transmission
1. Hex-washer bolts (1/4 x 1
inch)
2. Transmission cover
3. Drive belt
2. Move the cover forward until you can see the drive belt
(Figure 73).
3. Check the tapered faces of the primary clutch for signs
if damage (Figure
Note: If the faces of the primary clutch are damaged,
replace the primary clutch; contact your Authorized
Service Dealer or Authorized Distributor.
4. Check the drive belt for missing or damaged cogs
(Figure 73).
Note: If the cogs of the drive belt are missing or
damaged, replace the drive belt.
5. Measure across the belt and record the belt width
(.Figure 73).
Note: If the width of the belt is 29.5 mm (1.16 inch)
or less, replace the belt
6. Align the holes in the transmission cover with the holes
in the mounting plate
7. Secure the cover to the mounting plate
the 9 hex-washer bolts (1/4 x 1 inch) that you removed
49
(Figure 73).
Figure 73
4. Mounting plate
5. Tapered faces (primary
clutch)
6. Belt width—replace at
29.5 mm (1.16 inch) or
less
73).
(Figure 73).
(Figure 73).
(Figure 73) with