Toro 07390 Workman HDX-Auto Operator's Manual page 23

2. Remove the cap and dipstick from the filler neck of the
reservoir and wipe the dipstick clean with a rag
23 and Figure 24).
3. Insert the dipstick into the filler neck; then remove it
and check the fluid level
•
Non-TC model: the fluid level should be between
the lower indented area on the dipstick.
•
Non-TC model with the High Flow Hydraulic
Kit (option) or TC model: the fluid level should
be between the upper indented area on the dipstick.
4. If the level is low, add the specified hydraulic fluid into
the reservoir to raise the level to the middle of the
indented area on the dipstick
5. Install the dipstick and cap to the filler neck of the
reservoir (Figure 23
Checking the Coolant Level
Service Interval: Before each use or daily Check the Coolant
level at the overflow reservoir only. Do
Not remove the radiator cap. (Check the
coolant level before the engine is first
started and daily thereafter.)
Coolant type: a 50/50 solution of water and permanent
ethylene glycol antifreeze
1. Park the machine on a level surface.
CAUTION
If the engine has been running, the
pressurized, hot coolant can escape and cause
burns.
• Do not open the radiator cap.
• Allow the engine to cool at least 15 minutes
or until the radiator cap is cool enough to
touch without burning your hand.
• Use a rag when opening the reserve tank
cap, and open the cap slowly to allow
steam to escape.
• Do not check the coolant level at the
radiator; check the coolant level only at the
reserve tank.
2. Check the coolant level at the reserve tank
Note: The coolant should be up to the bottom of
the filler neck.
(Figure 23 and Figure
(Figure 23 and Figure
and Figure 24).
(Figure
(Figure
24).
24).
1. Coolant reserve tank
3. If coolant is low, remove the reserve tank cap and add a
50/50 mixture of water and permanent ethylene-glycol
antifreeze.
Note: Do not overfill.
4. Install the reserve-tank cap.
25).
23
G019522
Figure 25
1