Brake Fluid - BOMBARDIER DS 250 Operator's Manual

Add coolant up to MAX. mark if re-
quired. Use a funnel to avoid spillage.
Do not overfill.
Properly reinstall and tighten filler cap.
Reinstall front fender access cover.
If the coolant is added in the coolant
reservoir, check the level in the radia-
tor too. Add coolant if necessary.
WARNING
In order to avoid potential burns,
do not remove the radiator cap if
the engine is hot.
NOTE: A cooling system that fre-
quently requires coolant is the indi-
cation of leaks or engine problems.
See an authorized Bombardier ATV
distributor/dealer.
To gain access to the radiator, remove
front fender access cover (see proce-
dure above).
vmo2006-014-031_a
TYPICAL
1. Radiator cap
2. Coolant reservoir cap
Coolant Replacement
Refer to MAINTENANCE section.
______________________
78

Brake Fluid

Recommended Fluid
Always use brake fluid meeting the
specification DOT 4 only.
CAUTION: To avoid serious dam-
age to the braking system, do not
use fluids other than the recom-
mended one, nor mix different
fluids for topping up.
Fluid Level
With vehicle on a level surface, check
brake fluid in reservoir for proper level.
It should be above MIN. mark.
Add fluid as required. Do not overfill.
Clean filler cap before removing.
CAUTION: Use only DOT 4 brake
fluid from a sealed container. Do
not use brake fluid taken from old
or already opened containers.
NOTE: A low level may indicate
leaks or worn brake pads.
an authorized
distributor/dealer.
Handlebar Fluid Reservoirs
Turn handlebar in the straight-ahead
position to ensure reservoirs are lev-
eled. Check the brake fluid level, the
reservoir is full when the fluid reaches
of the top of window.
Visually inspect lever boot condition.
Check for cracks, tears, etc. Replace
if damaged.
See
Bombardier ATV