General International BS5202 Setup And Operation Manual page 6

SERVICE
1. INSPECT AND MAINTAIN THE TOOL REGULARLY.
Have it repaired only by an authorized repair technician.
2. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for better and safer performance. Follow
instructions for lubricating and safe performance. Follow instructions for
lubricating and changing accessories. Keep handles dry, clean and free
from oil and grease.
3. ENSURE THAT THE VENTILATION OPENINGS
are kept clear of debris.
4. IF THE CORDSET IS DAMAGED HAVE IT REPAIRED
only by an authorized service center.
5. SERVICE AND REPAIRS SHOULD BE MADE BY QUALIFIED REPAIR
TECHNICIANS
at an authorized repair center. Improperly repaired tools could cause
serious shock or injury.
6. REPLACEMENT PARTS.
When servicing, use only the manufacturer's recommended
replacement dentical replacement parts and accessories.
7. THE MANUFACTURER SHALL NOT BE LIABLE
for any changes made to the tool, nor for any damage resulting from
such changes.
SAFETY RULES SPECIFIC TO THIS EQUIPMENT
Because each shop situation is unique, no list of safety guidelines can
ever be complete. The most important safety feature in any shop is the
knowledge and good judgement of the user. Use common sense and
always keep safety considerations, as they apply to your individual shop
situation first and foremost in mind. If you have any doubts about the
safety of an operation you are about to perform: STOP! Do not perform the
operation until you have validated from qualified individuals if the operation
is safe to perform and what is the safest method to perform it.
WARNING! To avoid mistakes that could cause serious, permanent
injury, do not plug the tool in until the following steps have been
completed:
„ Assembly and alignment
„ Learn the use and function of the on/off switch and other adjustments.
„ Review and understanding of all safety instructions and operating
procedures in this manual.
„ Review of the maintenance methods for this tool.
1. READ THE WARNING LABELS ON THE TOOL.
2. AVOID UNINTENTIONAL STARTING.
Be sure the switch is in the OFF position before plugging in.
3. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING
KEYS OR WRENCHES
before turning the tool on. Left attached, these parts can fly off a
rotating part and result in personal injury.
4. DO NOT OPERATE THIS MACHINE UNTIL IT IS COMPLETELY
ASSEMBLED
and installed according to the instructions. A machine incorrectly
assembled can cause serious injury.
NOTE: If any parts are damaged or missing, do not attempt to plug in
the power cord and turn the switch on until the damaged or missing parts
are obtained and are installed correctly.
5. KEEP YOUR FACE AWAY FROM THE CUTTING AREA
to avoid inhaling any fumes which may be generated by oily
substances found on ferrous materials.
6. NEVER CLIMB OR STAND ON THE TOOL.
Serious injury could occur if the tool tips. Do not store anything above
or near the tool where anyone might stand on the tool to reach them.
6