Configuration With Wi-Fi Direct; Turn Off The Wireless Device - Pantum P2200 Series User Manual

5.1.2. Configuration with Wi-Fi Direct
When Wi-Fi Hotspot is active, terminal (Station) users can find and connect the printer's
Wi-Fi Hotspot by searching for it. The Wi-Fi Hotspot is enabled by default. It can be connected
without a password and coexist with Station or wired network.
Feature
1 SSID
2 Frequency band
3 IP Address
4 Subnet Mask
5 DHCP Service
6 DHCP service starting
address
7 DHCP service ending
address

5.2. Turn off the Wireless Device

If you want to disconnect the printer with the wireless network, you can turn off the wireless
device within the printer.
1. You can disconnect the wireless network by pressing the Wi-Fi button on the printer's
control panel for over 2 seconds.
2. To verify whether the wireless device is turned off, press and hold the Cancel/Continue
button to print a copy of the configuration page. The wireless network is disconnected
successfully if the printer's IP address on the configuration page is 0.0.0.0.
Description
Pantum-AP-XXXXXX by default
XXXXXX should be replaced with
the last three digits of the mac
address
Auto by default
192.168.223.1 by default
255.255.255.0 by default
Enabled by default
192.168.223.100 by default
192,168,223,200 by default
Comment
The XXXXXX section can be
modified in WebPage
Can be modified in WebPage
Can be modified in WebPage
Can be modified in WebPage
Can be modified in WebPage
Can be modified in WebPage
5-8