Ink ribbon is being fed from the tape outlet along with the tape.
Possible Causes
Tape cartridge loaded
Remove the tape cartridge and
while the ink ribbon is
check to make sure the ink ribbon is
slack.
not broken. Next, take up any slack
in the ink ribbon and then reload the
tape cartridge.
Important!
• Before loading a tape cartridge
into the label printer, always make
sure you take up any slack in the
ink ribbon fi rst.
• If the ink ribbon is broken, you
must change to another tape
cartridge.
• Tape Cutting
Cannot cut tape.
Possible Causes
Tape cutter blade is dull.
Take the label printer to the dealer
from whom you purchased it to have
the tape cutter blade replaced.
Printed text is cut off by tape cut operation.
Possible Causes
Out of tape
Replace the tape cartridge with a
new one.
Action
Page
7
Action
Page
—
Action
Page
7
• Using Labels
Label will not adhere to a surface.
Possible Causes
The backing paper is still
Peel the backing paper from the
on the back of the tape.
back of the tape to expose the
adhesive.
Surface is unsuitable for
Labels do not adhere well to
affi xing a tape.
surfaces that are rough, wet, oily, or
dirty.
Action
Page
13
13
19
EN