Seat ALTEA Owner's Manual page 56

54 Cockpit
Selecting a memory
– To change from one memory to another, briefly press button
⇒ F ig. 41 ⇒ p age 51 on the windscreen wiper lever or the
the multifunction steering wheel
is switched on.
Resetting a memory
– Select the memory where you wish to erase the values.
– Hold down button
A
on the multifunction steering wheel* for at least two seconds.
The trip memory 1 collects the travel and consumption data from the mo-
ment the ignition is switched on until it is switched off. If the journey is con-
tinued within two hours of switching off the ignition, the new values will be
added to the existing trip recorder memory. The memory will automatically
be deleted if the journey is interrupted for more than 2 hours.
Total memory 2 collects the trip data for any number of individual journeys
(even if the ignition is switched off for longer than two hours) up to a total of
19 hours and 59 minutes travel time or 1,999 km. The memory will automat-
ically be deleted if one of the named values is reached.
On-screen display
The following data can be viewed on the multifunction display using the
⇒ F ig. 41
rocker switch
B
⇒ F ig. 42
pressing button or
 
● Distance
● Average speed
● Driving speed
● Speed warning at --- km/h (mph)
● Journey duration
● Current fuel consumption
● Average fuel consumption
⇒ F ig. 42 ⇒ p age 51 while the ignition
on the windscreen wiper lever or the
⇒ p age 51 on the windscreen wiper lever or by
on the multifunction steering wheel*.
● Operating range
● Outside temperature
A
button on
OK
Distance travelled
The display shows the distance travelled since the ignition was switched on.
The maximum display value in both memories is 1,999 km (miles). The
memory will automatically be deleted once this value has been reached.
button
OK
in
Average speed
After starting the ignition, the average speed will be shown after a distance
of approximately 100 metres has been travelled. Until then dashes will ap-
pear in the display. The display will be updated every five seconds while the
vehicle is in motion.
km/h (mph) - Driving speed
Driving speed is digitally shown in the display.
Speed warning at --- km/h (mph)
This function may help you to keep within the speed limits. Press the
button on the windscreen wiper lever
wheel* to select the current speed. The instrument panel display gives the
selected speed, for example, Speed warning 120 km/h. You have five sec-
onds to reset the speed between 30 km/h (18 mph) and 250 km/h (155
mph) using rocker switch
ing wheel*. Press the
ed and the warning is activated. If the set speed is exceeded, an audible
warning is heard and a warning message is displayed until the speed is re-
duced to at least 4 km/h (2 mph) below the stored speed. The function is
switched off by pressing the
(miles) is now displayed on the instrument panel.
in and
Duration h
The display shows the amount of time which has elapsed since the ignition
was switched on.
in
km (miles)
km/h (mph)
or the multifunction steering
A
or buttons or on the multifunction steer-
B
 
button or wait five seconds until the speed is stor-
OK
button again. Speed warning --- km/h
OK
min
OK
