Applies to the model: ALTEA
Turn signal light
– Remove the lamp from its housing ⇒ p age 246.
⇒ F ig. 192
– Unscrew the bolts
on this.
– Pull out the turn signal bulb holder using a screw driver in the
direction of the arrow
Safety
Fig. 192 Turn signal
light.
Fig. 193 Turn signal
light.
from the bulb holder and pull
C
⇒ F ig.
193.
Operation
– Fit the replacement bulb by pressing it down and rotating to the
left.
– Installation involves all of the above steps in reverse sequence.
Applies to the model: ALTEA
Reverse light/rear fog light
– Rotate the bulb holder to the left, and remove it in the direction
⇒ F ig.
of the arrow
194.
– Replace the bulb by pressing on it and rotating at the same time
to the left
Advice
If and when
Fig. 194 Lamp on interi-
or side of bumper.
Technical specifications
247