TUNING THE CHASSIS
Adjusting the rebound damping of the fork
9.13
Info
The hydraulic rebound damping determines the fork suspension behavior.
Handlebar position
9.14
Adjusting the handlebar position
9.15
–
Remove protection caps
–
Turn adjusting screws
Info
Adjusting screws
Make the same adjustment on both fork legs.
–
Turn back counterclockwise by the number of clicks corresponding to the fork type.
Guideline
B00295-10
Rebound damping (All SX‑F EU models)
Comfort
Standard
Sport
Rebound damping (SX‑F USA)
Comfort
Standard
Sport
Rebound damping (XC‑F)
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
–
Mount protection covers
On the upper triple clamp, there are two holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
800116-10
x
–
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
.
1
clockwise all the way.
2
are located at the bottom end of the fork legs.
2
14 clicks
12 clicks
10 clicks
14 clicks
12 clicks
10 clicks
14 clicks
12 clicks
10 clicks
.
1
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar
1
. Remove the handlebar support.
2
M10
to each other.
A
from the center.
B
40 Nm
Loctite
®
243™
(29.5 lbf ft)
30
.
2