Changing The Speedometer Battery - KTM Freeride 250 R EU Owner's Manual

15 ELECTRICAL SYSTEM
15.12

Changing the speedometer battery

Main work
–
Adjust the beam distance of the headlight by turning screw
Guideline
For a motorcycle with rider, the light/dark boundary must be exactly on the lower
mark (the mark is created in: Checking the headlight setting).
Info
Turn clockwise to increase the headlight range, turn counterclockwise to
reduce the headlight range.
M01038-10
A change in weight on the vehicle may require a correction of the headlight
range.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
M01039-10
–
Using a coin, turn protection cap
–
Remove speedometer battery
–
Insert the new battery with the label facing outward.
Speedometer battery (CR 2032) (
–
Check the O-ring of the protection cap for correct seating.
M01040-10
–
Position protection cap
–
Press any button on the speedometer.
The speedometer is activated.
–
Position the speedometer in the holder.
–
Mount and tighten the screws with washers.
M01041-10
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Set the speedometer. (
 .
 all the way counterclockwise and remove it.

.
p. 98)

and turn all the way clockwise using a coin.
p. 78)
p. 19)

.
p. 75)
p. 76)
79