Checking The Headlight Setting(Freeride E-Xc); Adjusting The Headlight Range(Freeride E-Xc); Changing The Speedometer Battery(Freeride E-Xc) - KTM FREERIDE E-XC Owner's Manual

15 ELECTRICAL SYSTEM
15.9 Checking the headlight setting(Freeride E‑XC)
A 0 0 A
15.10 Adjusting the headlight range(Freeride E‑XC)
15.11 Changing the speedometer battery(Freeride E‑XC)
–
Check that the turn signal system is functioning properly.
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
B 0 0 B
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle with a full set of protective clothing.
–
Turn the key in the ignition lock to the position
–
Push the main switch into the position
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Adjust the beam distance of the headlight by turning screw
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (instructions on how to apply the mark: Checking the
headlight setting).
Info
Turn clockwise to increase the headlight range, turn counterclockwise to
C00818-10
reduce the headlight range.
A change in weight on the vehicle may require a correction of the headlight
range.
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
C00819-10



p. 94)
p. 37)
p. 63)
p. 96)
p. 64)

.
under the first mark.
5 cm (2 in)

away from the wall.
5 m (16 ft)
.
.
p. 94)

.
p. 91)
94