Checking The Headlight Setting; Adjusting The Headlight Range; Changing The Speedometer Battery - KTM 350 EXC-F Owner's Manual

15 ELECTRICAL SYSTEM
15.10

Checking the headlight setting

15.11

Adjusting the headlight range

15.12

Changing the speedometer battery

Finishing work
–
Check that the turn signal system is functioning properly.
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
L02459-10
A change in weight on the vehicle may require a correction of the headlight
range.
–
Tighten screw
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
M00191-10

under the first mark.


p. 95)

.

.

.
5 cm (2 in)
 away from the wall.
5 m (16 ft)
p. 95)
p. 92)
95