Table of Contents
Advertisement
15
ELECTRICAL SYSTEM
15.9
Checking the high beam headlight adjustment
A
0 0 A
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range of the low beam. (
–
Position the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
B
0 0 B
Distance
–
Position the vehicle perpendicular to the wall at a distance
on the high beam.
Guideline
Distance
–
The rider, with luggage and passenger if applicable, now mounts the motorcycle.
–
Check the high beam headlight adjustment.
The center of the light cone must lie exactly on the lower mark when the motorcycle
0 0 B
B
is ready to operate with the rider mounted along with any luggage and a passenger if
applicable.
»
If the center of the light cone is not located where specified:
–
Adjust the headlight range of the high beam. (
400575-10
under the first mark.
p. 146)
5 cm (2 in)
from the wall and switch
5 m (16 ft)
p. 146)
145
Advertisement
Table of Contents
