Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
(RC 125)
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn the adjusting screws
left and right chain adjusters
ence marks
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
L02150-10
Guideline
Nut, rear wheel spindle
.
.
on the left and right so that the markings on the
are in the same position relative to the refer-
. The rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even, so you should check the setting at different
chain positions.
.
.
on the left and right.
5... 7 mm (0.2... 0.28 in)
are fitted correctly on adjusting screws
M14x1.5
91
.
90 Nm
(66.4 lbf ft)
Advertisement
Table of Contents
