MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking the high beam headlight adjustment
9.52
A
0 0 A
–
Check the low beam headlight adjustment.
The boundary between light and dark must be exactly on the lower mark for a motor-
cycle with driver.
»
If the boundary between light and dark does not meet specifications:
–
Adjust the light range of the low beam headlight. (
–
On a light-colored wall behind a horizontal area, make a mark as high as the center of
the high beam headlight.
–
Make another mark at a distance of
Guideline
Distance
0 0 B
B
–
Stand the motorcycle at a distance of
beam.
Guideline
Distance
–
Check the high beam headlight adjustment.
The center of the light cone must be exactly at the lower mark when the motorcycle is
operational and complete with a rider.
»
If the center of the light cone is not located where specified:
0 0 B
B
–
Adjust the light range of the high beam headlight. (
400575-10
p. 112)
under the first mark.
5 cm (2 in)
in front of the wall and switch on the high
5 m (16 ft)
p. 113)
111