Table of Contents
Advertisement
14
WHEELS, TIRES
(RC 125)
–
Remove spacers
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
L02183-11
–
Clean the thread of the wheel spindle and screw
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Position wheel speed sensor
Guideline
Screw, wheel speed sensor holder
–
Mount and tighten screws
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
–
Take the motorcycle off of the front wheel stand. (
–
Pull the front brake and compress the fork forcefully a few times.
The fork legs straighten.
L02182-11
.
Change the front wheel bearing.
p. 198)
.
in the drill hole. Mount and tighten screw
.
and mating surfaces
.
M8
26 Nm
(19.2 lbf ft)
M6
8 Nm (5.9 lbf ft)
p. 80)
120
of the spacers.
.
Advertisement
Table of Contents
