Installing On The Ceiling - Sanyo vcc-n6695p Installation Manual

Installing on the Ceiling

1. Remove the base plate from the
camera unit
Pushing the base plate lock (A), open the
base plate in the arrowed direction.
2. Install the base plate
1
Pass the connection cables through the
cable hole on the base plate.
2
Position the arrow (2) on the base plate
in the direction of the lens.
3
Set the base plate on the ceiling and
tighten it securely using suitable screws
and washers (B).
[Screws]
• Length: 35 mm or more
• Diameter: 3.5 to 5.0 mm
• Height of screw head: 5 mm or less
(washer included)
2
B
Make sure to tighten the screws properly.
Using screws of sizes other than
specified may cause the unit to fall.
A
1
B
Unplug the PoE power supply hub.
3. Connect the cables from the ceiling
Push the excess of connected cables into
the ceiling. For details on the connections,
see page 9.
Pass the LAN cable through the camera in order
to plug it into the LAN port on the network board
after removing the dome cover.
3
See step under "5. Remove the dome
cover" on page 6.
4. Mount the camera unit to the base
plate
Aligning the ribs (C) and hook (D) on the
camera unit with the slot on the base plate,
push the camera unit until it clicks.
C
D
Make sure that the camera unit and base
plate fit perfectly.
5