Advertisement
In-ceiling Mount (Closed Type)
Make sure to also consult the In-ceiling Bracket Closed Type Instruction Manual.
1. Installing the power board unit
1 Draw a circumference on the ceiling using the
supplied drop-prevention cable (A) as compass, and
drill a hole for installing the in-ceiling bracket.
2 Pull out the cables from the ceiling.
3 Pass the supplied screws (B) through each of the
power board unit screw holes and fasten them
loosely using washers (4 places).
4 Align the arrows (C) of the same color (blue) on the
power board unit and the in-ceiling bracket, and
mount the power board unit. Tighten firmly the
screws (B) loosely fastened in the previous step.
● Pass the video cable (D) through the bracket cable
hole as preparation for the next step.
2. Installing on the ceiling
5 Attach the supplied safety wire (E) to the ceiling
beam, for example, then connect it to the bracket-top
hook (F).
6 Connect the video cable and pass the connection
cables through the bracket.
7 Insert the bracket into the ceiling hole and fix it
using screws (G) (2 places).
8 Connect the cables and set the switches.
☞ See "Connections and Settings" on page 5.
9 Align the arrows (C) of the same color (blue) on the
camera unit and the inner side of the bracket, and
push the camera unit until they click.
F Align the SANYO logos on the supplied bracket
cover and the bracket, and push the cover until they
click.
■ How to attach the drop-prevention cable
(accessory)
Fasten the drop-prevention cable (A) to the hooks (H) on
the bracket and its cover, then slide the cable as shown in
the figure.
H
A
Accessories
Screw, washer
(for power board unit)
Safety wire
H
Drop-prevention
cable
Bracket cover
φ192 mm (7.6")
1
A
C; Blue
2
6
7
5
G
9
– 3 –
3
3
3
4
D
E
F
F
G
7
8
G
F
C; Blue
To remove the camera unit
3
B
E
5
G
Advertisement
