Menu 5 - Service - Nibe F1145 Installer Manual

Menu 5 - SERVICE

5 - SERVICE
* Accessory needed.
Hold the Back button in for 7 seconds to access the Ser-
vice menu.
Sub-menus
Menu SERVICE has orange text and is intended for the
advanced user. This menu has several sub-menus. Status
information for the relevant menu can be found on the
display to the right of the menus.
operating settings Operating settings for the heat pump.
system settings System settings for the heat pump, ac-
tivating accessories etc.
accessory settings Operational settings for different ac-
cessories.
soft in/outputs Setting software controlled in and out-
puts on the input circuit board (AA3).
factory setting service Total reset of all settings (including
settings available to the user ) to default values.
forced control Forced control of the different compon-
ents in the heat pump.
start guide Manual start of the start guide which is run
the first time the heat pump is started.
quick start Quick starting the compressor.
NIBE™ F1145
Overview
5.1 - operating settings
5.2 - system settings
5.3 - accessory settings
5.4 - soft in/outputs
5.5 - factory setting service
5.6 - forced control
5.7 - start guide
5.8 - quick start
5.9 - floor drying function
5.10 - change log
Menu 5.1 - operating settings
Operating settings can be made for the heat pump in the
sub menus.
5.1.1 - hot water settings *
5.1.2 - max flow line temperature
5.1.3 - max diff flow line temp.
5.1.4 - alarm actions
5.1.5 - fan sp. exhaust air *
5.1.7 - br pmp al set.
5.1.8 - operating mode brine pump
5.1.9 - brine pump speed
5.1.10 - op. mod heat med pump
5.1.11 - pump speed heating medium
5.1.12 - internal electrical addition
5.3.1 - FLM *
5.3.2 - shunt controlled add. heat *
5.3.3 - extra climate system *
5.3.4 - solar heating *
5.3.6 - step controlled add. heat *
NOTE
Incorrect settings in the service menus can
damage the heat pump.
Chapter 8 | Control - Menus 49