Vimtag VT-361 User Manual page 24

USER MANUAL
connected to the camera. The settings aren't changeable with external devices,
and most people will never have to worry about this setting.
Once again, when you do make changes on the sensitivity settings, you need to
hit the apply button to ensure they go through.
Alarm Action
Under the Alarm Action tab, under the name section at the top, you will be able
to choose between Motion and I/O alarm. Again, most people will not be using
the I/O alarms, and will instead be using the Motion alarm, which is the default
setting. Most will leave it on this setting. Make sure that you have enabled the
camera's Motion alarm. It should read "ON" in the section just below the name.
Below that, the Alarm Sources row will let you know that you are using motion
alarms.
Below that, you can choose to turn on or off a variety of different alarm actions.
When the camera captures motion, it will provide you with an alert. You can
choose to have the camera send an I/O alarm (again, this is rarely used by most
people and you should keep it off), or you can have it take a snapshot or start
recording. You can set the prerecorded length, which will allow you to start the
recording a few seconds before the camera starts to record motion. The default is
three seconds, but you can set it for up to six seconds.
Once you make the changes, hit apply, as always. Then, you must hit the Turn
24