Linking And Unlinking The Remote Keyless Entry Key Fob To Memory - Chrysler 2016 300 Owner's Manual

146 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Linking And Unlinking The Remote Keyless Entry
Key Fob To Memory
Your RKE Key Fob can be programmed to recall one of
two pre-programmed memory profiles by pushing the
UNLOCK button on the RKE Key Fob.
NOTE: Before programming your RKE Key Fob you
must select the "Memory To FOB" feature through the
Uconnect system screen. Refer to "Uconnect Settings" in
"Understanding Your Instrument Panel" for further in-
formation.
To program your RKE Key Fob, perform the following:
1. Cycle the vehicles ignition to the Off position.
2. Select desired memory profile (1) or (2). The system
will recall any stored settings for this profile. Wait for
the system to complete the memory recall before
continuing to Step 3.
NOTE: If a memory profile has not already been set, refer
to Programming The Memory Feature in this section for
instructions on how to set a memory profile.
3. Once the profile has been recalled, push and release
the SET (S) button on the memory switch, then push
and release button (1) or (2) accordingly. "Memory
Profile Set" (1 or 2) will display in the instrument
cluster.
4. Push and release the LOCK button on the RKE Key
Fob within 10 seconds.
NOTE: Your RKE Key Fobs can be unlinked to your
memory settings by pushing the SET (S) button, and
within 10 seconds, followed by pushing the UNLOCK
button on the RKE Key Fob.