Service The Parksense Park Assist System - Chrysler 2016 300 Owner's Manual

224 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
switch is pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the LED
will be ON.

Service The ParkSense Park Assist System

During vehicle start up, when the ParkSense System has
detected a faulted condition, the instrument cluster will
actuate a single chime, once per ignition cycle, and it will
display the PARKSENSE UNAVAILABLE WIPE REAR
SENSORS , PARKSENSE
FRONT SENSORS , or the PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED message for five seconds.
When the gear selector is moved to Reverse and the
system has detected a faulted condition, the Driver
Information Display (DID) will display a PARKSENSE
UNAVAILABLE WIPE REAR SENSORS , PARKSENSE
UNAVAILABLE WIPE
PARKSENSE UNAVAILABLE SERVICE REQUIRED
pop up message for five seconds. After five seconds, a
UNAVAILABLE WIPE
FRONT SENSORS
vehicle graphic will be displayed with UNAVAILABLE
at either the front or rear sensor location depending on
where the fault is detected. The system will continue to
provide arc alerts for the side that is functioning properly.
These arc alerts will interrupt the PARKSENSE UN-
AVAILABLE WIPE REAR SENSORS , PARKSENSE UN-
AVAILABLE WIPE FRONT SENSORS , or PARKSENSE
UNAVAILABLE SERVICE REQUIRED messages if an
object is detected within the five second pop-up duration.
The vehicle graphic will remain displayed for as long as
the vehicle is in REVERSE. Refer to "Driver Information
Display (DID)" for further information.
If PARKSENSE UNAVAILABLE WIPE REAR SENSORS
or PARKSENSE UNAVAILABLE WIPE FRONT SEN-
SORS appears in the Driver Information Display (DID)
make sure the outer surface and the underside of the rear
or
fascia/bumper and/or front fascia/bumper is clean and