Linking And Unlinking The Remote Keyless Entry Transmitter To Memory - Chrysler 1500 Owner's Manual

164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Vehicles Not Equipped With Keyless Enter-N-Go
1. Insert the ignition Key Fob, and turn the ignition
switch to the ON/RUN position.
2. Adjust all memory profile settings to desired prefer-
ences (seat, side mirrors, adjustable pedals [if
equipped], power tilt and telescopic steering column
[if equipped], and radio station presets).
3. Press and release the S (Set) button on the memory
switch.
4. Within five seconds, press and release either of the
memory buttons (1) or (2). The Electronic Vehicle
Information Center (EVIC) will display which
memory position has been set.
NOTE: Memory profiles can be set without the vehicle
in PARK, but the vehicle must be in PARK to recall a
memory profile.
Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory
Your RKE transmitters can be programmed to recall one
of two pre-programmed memory profiles by pressing the
UNLOCK button on the RKE transmitter.
NOTE: Before programming your RKE transmitters to
memory and If your vehicle is equipped with a touch-
screen, you must select the "Memory To FOB" feature
through the Uconnect® system. Refer to "Uconnect®
Settings " in "Understanding Your Instrument Panel" for
further information.
If your vehicle is not equipped with a touchscreen, you
must select the "Key Fob Linked To Memory" feature
through the Electronic Vehicle Information Center
(EVIC). Refer to "Electronic Vehicle Information Center
(EVIC)" in "Understanding Your Instrument Panel" for
further information.