Terminal Panel Features - NEC NP3200 User Manual

Terminal Panel Features

The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not af-
fect the projector's performance.
1. COMPUTER 1 IN/Component Connector (Mini D-
Sub 15 Pin) (→ page 13, 16, 17)
AUDIO IN (Stereo Mini Jack) (→ page 13, 16, 17)
2. COMPUTER 2 IN/Component (R/Cr, G/Y, B/Cb, H,
V) Connectors (BNC × 5) (→ page 13, 18)
AUDIO IN (Stereo Mini Jack) (→ page 13)
3. COMPUTER 3 (DVI-D) IN Connector (24 Pin)
(HDCP compatible) (→ page 15)
AUDIO IN (Stereo Mini Jack) (→ page 15)
4. S-VIDEO IN Connector (Mini DIN 4 Pin) (→ page
18)
5. VIDEO IN Connector (RCA) (→ page 18)
6. VIDEO/S-VIDEO AUDIO L/MONO, R (RCA) (→
page 18)
7. MONITOR OUT Connector (Mini D-Sub 15 Pin)
(→ page 16)
Downloaded From projector-manual.com NEC Manuals
10
4 5 6 1
3
7 8
8. AUDIO OUT (Stereo Mini Jack) (→ page 16)
9. PC CONTROL Port (D-Sub 9 Pin) (→ page 96, 97)
Use this port to connect your PC or control system
to control your projector via a serial cable. This
enables you to control the projector using serial
communication protocol. A commercially available
RS232C cross cable is required to use this port. You
can also control the projector by using PC Control
Utility Pro 4 contained on the supplied NEC Projec-
tor CD-ROM. To do so you must first have PC Con-
trol Utility Pro 4 installed on your PC (→ page 48). If
you are writing your own program, typical PC control
codes are on page 96.
10. LAN Port (RJ-45) (→ page 19)
8
1. Introduction
2
9