Installation Projector
NP3200/NP2200/NP1200
Eco-friendly projector capable for
flexible installation and versatile
uses with five optional lenses,
lens shift and many other features.
Low power consumption in power-saving mode
Power consumption in power-saving mode is 0.4W (100-120V AC) /
0.5W (200-240V AC). These enhancements help to dramatically
reduce the TCO (total cost of ownership).
Carbon meter for visualizing ecology
The projector employs the Carbon
Meter indicating the reduced amount
of CO
emissions in Eco Mode.
2
Visually confirm the numerical value
indicating the reduction in CO
emissions in comparison with Eco Mode Off operation.
Quick start & Quick power off
Your projector is setup and ready to display your presentation about
5 seconds after powering on, with the Quick Start function. The
Quick Power Off function stops the cooling fan immediately after
turning off the power to the projector, which makes it possible to
remove the projector quickly.
Direct power off
For a rapid shut down, the projector can be turned off without
powering off the projector using the Direct Power Off function and a
power strip equipped with a switch and breaker.
High Brightness up to 5000 ANSI Lumens (NP3200)
Vertical Keystone Correction +/-30 degrees
Wall Colour Correction for vivid images even without a
screen
2
Virtual Remote Function is easy and convenient to
set up on the projector
The included Virtual Remote Tool utility software allows to
manipulate the projector from your PC connected with VGA signal
cable. In addition, the Easy Setup function gives simple instructions
for setting up the projector.
For the operating screen,
you can select either the toolbar
or the remote controller type.
Five types of optional lenses available for
Flexible installation
Five optional lenses are selectable for various installation conditions
depending on the screen size, room space, throwing distance, etc.
Lenses can be easily replaced by hand without using tools.
Manual lens shift for simple adjustment of
projected images on screen
With the manual lens shift mechanism, the position of projected
images on screen can be adjusted in both the vertical and horizontal
directions without moving the main unit.
*The Lens Shift function is not available for the NP01FL.
Wired LAN Connectivity
Auto Power On starts projection immediately by inserting
the power cord into an outlet
High altitude mode (5500ft / 1600m)
http://www.nec-display.com/ap/
Source Select
Freeze
Help
Power
AV-MUTE
Option
(Indication of the toolbar/
Adjustment of the button sizes)