Battery Installation; Operating Range For Wireless Remote Control - NEC NP3200 User Manual

Battery Installation

1
Press firmly and slide the battery
cover off.

Operating Range for Wireless Remote Control

7 m/22 feet
30°
30°
Remote sensor on projector cabinet
30°
30°
7 m/22 feet
NOTE: Actual operating range may differ slightly from that shown in the drawing.
TIP: You can determine which remote sensor on the projector is enabled in wireless mode. The options are: [FRONT/BACK],
[FRONT], or [BACK]. ( → page 68)
• The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle
of the remote sensor on the projector cabinet.
• The projector will not respond if there are objects between the remote control and the sensor, or if strong light
falls on the sensor.
Weak batteries will also prevent the remote control from properly operating the projector.
Downloaded From projector-manual.com NEC Manuals
2
Install new batteries (AAA). En-
sure that you have the batteries'
polarity (+/−) aligned correctly.
7 m/22 feet
30°
30°
Remote control
Remote control
30°
30°
7 m/22 feet
10
1. Introduction
3
Slip the cover back over the bat-
teries until it snaps into place. Do
not mix different types of batter-
ies or new and old batteries.