NEC NP3200 User Manual page 83

[OPTIONS(2)]
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN
3 MINUTES] message will be displayed on the bottom of the screen.
Selecting Power-saving in [STANDBY MODE]
The projector has two standby modes: [NORMAL] and [POWER-SAVING].
The POWER-SAVING mode is the mode that allows you to put the projector in the power-saving condition which
consumes less power than the NORMAL mode. The projector is preset for NORMAL mode at the factory.
NORMAL ���������������� Power indicator: Orange light/STATUS indicator: Green light
POWER-SAVING ���� Power indicator: Red light/STATUS indicator: Off
NOTE:
• When [CONTROL PANEL LOCK], [CONTROL ID], or [AUTO POWER ON(COMP1/2)] is turned on, the [STANDBY MODE] setting
is not available.
• Your setting will not be affected even when [RESET] is done from the menu.
Enabling Auto Power On [AUTO POWER ON(AC)]
Turns the projector on automatically when the power cable is inserted into an active power outlet. This eliminates
the need to always use the POWER button on the remote control or projector cabinet.
Downloaded From projector-manual.com NEC Manuals
The following connectors, buttons or functions will not work during this mode�
- PC CONTROL port, MONITOR OUT connector, and AUDIO OUT connector
- LAN and Mail Alert functions
- Buttons other than POWER button on the cabinet
- Buttons other than POWER ON button on the remote control
- Virtual Remote function
72
5. Using On-Screen Menu