Table of Contents
Advertisement
Connect Electric Power
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL INSTRUCTED TO DO SO.
Connect to properly fused and earthed power outlet.
- Ensure all ropes and installation tools have been removed from the door.
- When the opener is switched ON, the operator light flashes a number of times and then remains ON.
19
Travel limits regulate the points at which the door will stop
PROGRAM THE TRAVEL LIMITS AND FORCE SETTINGS
when moving UP or DOWN. The travel limit buttons are located
under the light cover (figure 1).
NOTE: The opener will MOVE AUTOMATICALLY after setting the
DOWN limit at step 6. A complete UP DOWN cycle is performed
in order to "Set the Force" automatically. If the door is
interrupted during this process, the force will not be set and
the process will have to be repeated.
REFER TO THE DIAGRAMS:
1. Turn the Power ON and open the light cover. (The courtesy LEDs
will be on during this operation, and you may need to cover these
in order to see the program buttons clearly).
2. Press the "P" button until LED 3 starts flashing.
3. Press and hold the "+" button until the door moves to the desired
UP position. The "+" and "-" buttons can be used to move the
door UP and DOWN if required.
4. Press the "P" button to set the UP limit. LED 2 starts flashing.
5. Press and hold the "-" button until the door moves to the desired
DOWN position. The "+" and "-" buttons can be used to move
the door UP and DOWN if required.
6. Press and release the "P" button to set the DOWN limit. At this
point the opener will operate AUTOMATICALLY a complete cycle.
This will set the force of the motor, all LED indicators will stop
after this operation.
LIMITS AND FORCE ARE NOW SET.
SETTING THE FORCE (MANUAL LEARN IF REQUIRED):
If the limits are already set, the force can be set manually if
required.
1. Start with the door closed.
2. Disconnect the mains power from the opener for approx.10
seconds.
3. Using the remote control, Open and Close the door one complete
cycle.
The Force Setting has now been set manually.
Without a properly installed safety reversal
system, persons (particularly small children)
could be SERIOUSLY INJURED or KILLED by
a closing door.
• Incorrect adjustment of garage door travel limits will
interfere with proper operation of safety reversal
system.
• NEVER use force adjustments to compensate for a
binding or sticking garage door.
• After ANY adjustments are made, the safety reversal
system MUST be tested. Door MUST reverse on
contact with 40 mm high object laid flat on floor.
ADJUSTMENT SECTION
To prevent damage to vehicles, be sure fully open
door provides adequate clearance.
2
3
4
5
6
11
1
3 2
2
1
S
P
1
2
3 2
2
1
S
P
1
2
3 2
2
1
S
P
1
2
3 2
2
1
S
P
1
2
3 2
2
1
S
P
1
2
3
3
▲
▐
3
3
3
Hide quick links:
Advertisement
Table of Contents
