Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Merlin MT60P
Summary of Contents for Merlin MT60P
- Page 3 8mm hex 10mm, 8mm, head driver 4.5mm, 4mm 11mm, 13mm...
- Page 4 3m Chain Pack and Joiner Pole Adaptor Kit Segmented Pole Pack...
- Page 5 DOOR...
- Page 6 Absolute minimum stop collar setting...
- Page 7 Connecting the chain Lock nut Rotate adjuster Lock nut...
- Page 8 CEILING MOUNT ONLY 50mm (or 200mm) CEILING MOUNT ONLY 150mm fig 1...
- Page 9 Pole 50mm (2”) Header above the highest Bracket point of travel 50mm spacer should Door be used to determine the correct mounting position 50mm (2”) above the highest Pole point of travel Header Bracket Door 50mm spacer should be used to determine the correct mounting position Header...
- Page 10 DOOR DOOR DOOR Engaged Disengaged...
- Page 11 24V/21W Max. A. 0-100mm B. 150-250mm Figure 4 Door Bracket R-Clip Nuts Lock Washers Straight Clevis Pin Curved Door Arm Figure 5 Trolley Correct Angle Door with Backward Slant Open Door (Incorrect)
- Page 12 Figure 1 Pulley Trolley Ring Clevis Pin Fastener Emergency Release Door Handle Bracket Straight Door Arm Curved Door Arm Figure 2 Trolley Pulley Figure 3 Trolley Pulley HARDWARE PROVIDED...
- Page 13 (2x)
- Page 14 40mm 40mm SAFETY FIRST! white/black wires twisted together 4. grey 3. white white wires twisted together...
- Page 19 CM844 C940 C943 C945 CM128 C379 C198 CM1702 760E C840 ENROLL SEND ENROLL PASS FAIL READY RETRY...
- Page 20 041A2828 178B0086B 012B0905 178B0034B 012B0906 083A0011-1 002A1659 002A1658 001A7350 012B0415 PDR30005 2.75m Segmented Pole Pack 001A5643-23 184A0242 001A6829 142A0229 012A0928 142A0230...
- Page 21 158A0049 041A5797 041A5908 041A5735C 041A0079 041D0577 204C0240-2 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazard. 031D0587 108C0082...
- Page 24 Chamberlain reserves the right to change the design and specifications of the Unit without prior notification.
Need help?
Do you have a question about the MT60P and is the answer not in the manual?
Questions and answers
Door lowers to floor but wants to immediately go back up. How do l fix that?
To fix a Merlin MT60P door that lowers to the floor but immediately goes back up, you need to reset the DOWN (close) limit:
1. Press and hold the black button until the yellow light flashes slowly, then release.
2. Use the black button to move the door up and the orange button to move it down.
3. Adjust the door to the correct DOWN position so it fully closes without excess pressure (rail should not bow, chain should not sag).
4. Press the transmitter or door control to set the DOWN limit.
5. Test the door by opening and closing it with the transmitter.
This should stop the door from reversing when it reaches the floor.
This answer is automatically generated
Remote opens & closes door inside garage but doesn't open door from outside.
The issue with the Merlin MT60P remote not opening the garage door from outside could be due to one or more of the following:
1. The opener has not learned the remote code – The remote must be programmed into the opener using the orange “learn” button.
2. The remote battery is low or dead – If the transmission range decreases, the battery should be replaced.
3. The remote code was erased – If all transmitter codes were erased, the remote must be reprogrammed.
4. Weather-related changes – Weather conditions may affect door operation, requiring limit and force re-adjustments.
Reprogram the remote and check the battery to resolve the issue.
This answer is automatically generated