Changing The Handset Name - Panasonic KX-TG6811E Operating Instructions Manual

Programming
Important:
R Set the date and time beforehand
R We recommend turning the base unit ringer
R If you have set the alarm, the alarm sounds
Turning night mode on/off
1
2
3
4
5
Changing the start and end time
1
2
Setting the ring delay
This setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select "No Ringing",
the handset never rings during night mode.
1
2
Note:
R When the answering system answers the
30
TG68xxE(en)_1225_ver012.pdf
Downloaded from www.Manualslib.com
(page 16).
off (page 26) in addition to turning the night
mode on. (KX-TG6821 series: page 3)
even if the night mode is turned on.
M N#238
MbN: Select the desired setting. a MOKN
R If you select "Off", press MeN to
exit.
Enter the desired hour and minute you
wish to start this feature. a MOKN
R You can select 24-hour or 12-hour
clock format ("AM" or "PM") by
pressing *.
Enter the desired hour and minute you
wish to end this feature. a MOKN
MeN
R When the night mode is set,
displayed.
M N#237
Continue from step 3, "Turning night
mode on/off", page 30.
M N#239
MbN: Select the desired setting. a MOKN
a MeN
call, this feature does not work.
(KX-TG6821 series: page 3)
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
30
manuals search engine

Changing the handset name

Each handset can be given a customised
name ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is "No". If you select
"Yes" without entering any handset name,
"Handset 1" to "Handset 6" is displayed.
1
M N#104
2
Enter the desired name (max. 10
characters; page 45).
R If not required, go to step 3.
3
MOKN
4
MbN: Select the desired setting. a MOKN
2 times
5
MeN
Incoming call barring (Caller ID
subscribers only)
This feature allows the unit to reject calls from
is
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit emits no sound to the caller, and
disconnects the call.
Important:
R When the unit receives a call from a
number that is stored in the call barred list,
the call is logged in the caller list
(page 34) with
disconnected.
Storing unwanted callers
You can store up to 50 phone numbers in the
call barred list.
Important:
R You must store the phone number with an
area code in the call barred list.
n From the caller list:
1
MCN ( )
2012/12/25
after the call is
16:30:12