Other Programming; Operating Additional Units; Additional Handsets; Registering A Handset To The Base Unit - Panasonic KX-TGE432 Operating Instructions Manual

Answering the baby monitor
n When monitoring with a unit:
Handset: Press M
Base unit: Press M
*1 KX-TGE440 series: page 3
If you want to respond from the monitoring
unit, press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom
feature is set to "On" (page 21).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset,
press MOFFN, then press M
– To answer the call with the base unit,
press MZN 3 times.
*1 If MMUTEN is pressed, press MZN 2
times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.

Other programming

Changing the handset name

The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 37).
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
For assistance, please visit http://shop.panasonic.com/support
TGE43xUS(en)_1112_ver021.pdf 37
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
N to answer a call.
default setting is "Off".
*1
N to answer a call .
1
2

Registering a unit

Operating additional units

Additional handsets

N.
Up to 6 handsets can be registered to the
base unit.
*1
Important:
R See page 5 for information on the available
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
2
3
Programming
MMENUN#105
MbN: Select the desired setting. a
MSAVEN a MOFFN
model.
Handset:
MMENUN#130
Base unit:
Press and hold MLOCATORN or
MHANDSET LOCATORN for about 5
seconds.
R If all registered handsets start ringing,
press MLOCATORN or MHANDSET
LOCATORN again to stop, then repeat
this step.
Handset:
Press MOKN, then wait until a long beep
sounds.
37
2015/11/12 10:12:57