Anonymous Calls (Block Caller Id); Changing The Base Unit Pin (Personal Identification Number); Changing The Handset Name; Date And Time - Panasonic KX-TGP500 User Manual

Programming using the Handset
Y
Viewing/editing/erasing bar call
numbers
1
{MENU} (centre of joystick) i
{#}{2}{1}{7}
2
{V}/{^}: Select the desired entry.
L To exit, press {OFF}.
3
Proceed with the desired operation.
■ Editing a number:
{MENU} i {V}/{^}: "Edit" i
{SELECT} i Edit the phone number. i
{SAVE} i {OFF}
■ Erasing a number:
{MENU} i {V}/{^}: "Erase" i
{SELECT} i {V}/{^}: "Yes" i
{SELECT} i {OFF}
Note:
L When editing, press the desired dial key to add,
{CLEAR} to erase.
Anonymous calls (Block
Caller ID)
This feature allows the unit to make a call
anonymously.
The default setting is "Off".
Important:
L We recommend setting with your administrator.
Contact your administrator for further
information.
1
{MENU} (centre of joystick)
2
{V}/{^}: "IP Service" i {SELECT}
3
{V}/{^}: "Call Features" i {SELECT}
4
{V}/{^}: "Block Caller ID" i
{SELECT}
5
Proceed with the desired operation.
■ When 1 line is registered:
Go to step 6.
■ When 2 or more lines are registered:
{V}/{^}: Select the desired line. i
{SELECT}
6
{V}/{^}: Select "On" or "Off". i {SAVE}
i {OFF}
32
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make note of your
new PIN. The unit will not reveal the PIN to you.
If you forget your PIN, contact your phone
system dealer.
1
{MENU} (centre of joystick) i
{#}{1}{3}{2}
2
Enter the current 4-digit base unit PIN (default:
"0000").
3
Enter the new 4-digit base unit PIN. i {OK}
i {OFF}

Changing the handset name

Each handset can be given a customised name
("Bob", "Kitchen", etc.). This is useful when you
make intercom calls between handsets. You can
also select whether or not the handset name is
displayed in standby mode. The default setting is
"Off". If you select "On" without entering any
handset name, "Handset 1" to "Handset 6" is
displayed.
1
{MENU} (centre of joystick) i
{#}{1}{0}{4}
2
Enter the desired name (10 characters max.;
see the character table, page 50).
L If not required, go to step 3.
3
{OK}
4
{V}/{^}: "On" i {SAVE} i {OFF}

Date and time

Set if the unit does not show the date and time. You
can set the date and time through the Web user
interface and also program it to adjust
automatically using the SNTP. Also summer time
setting is available through the Web user interface.
Contact your administrator for further information.
1
{MENU} (centre of joystick) i
{#}{1}{0}{1}
Document Version 2012-08