Mounting Procedure For Drs2D/4D - Furuno DRS2D Installation Manual

Radar sensor
Radar sensor
1.2

Mounting Procedure for DRS2D/4D

1. Remove mounting hardware at the bottom of the radar sensor, four each of hex bolts
(M10x20), spring washers and flat washers. Save the spring washers and flat washers to use
them to fix the radome base to the platform, at step 3. If the thickness of the mounting platform
is 5 mm or less, also save the bolts.
Stern
Cable entry
2. Construct a platform (steel or aluminum) 6-10 mm in thickness referring to the outline drawing
at the back of this manual. Fasten the platform to the mounting location. Next, position the
base so the cable entrance is facing the stern.
Note: When drilling holes in the platform, be sure they are parallel with the fore and aft line.
For DRS2D/4D
Screws
(two screws on other side)
Flat washer
Spring washer
Hex bolt (M10 x 20)
Radar sensor
2
Radar sensor
Bow