Furuno DRS2D Installation Manual page 29

the crimp-on lug (pre-attached at the bottom of the chassis) to the drain wire, and fasten it with
the screw shown below.
NMEA connector
Fasten the drain wire with this screw.
5. Depending on the NMEA2000 used, replace the gasket as shown below.
DRS4A/6A/12A
Cable type
Gasket Use the gasket supplied in the plastic
bag inside the radar sensor.
DRS25A
Cable type
Gasket Use the gasket supplied in the plastic
bag inside the radar sensor.
6. Refer to the illustration shown on next page, and attach the gasket to the two-way cable
inserting the cable into the slits on the gasket.
7. Slide the gasket on cables so that the amount of cable above the gasket is lower than the RF
chassis.
8. Do steps 8 and 9 on the previous page.
A
RF unit
M12-05BFFM (φ6)
M12-05BFFM (φ6)
Gasket
Washer
NMEA connector
Crimp-on lug
Drain wire
CB-05BFFM (φ10)
Use the optional gasket. (Type: OP03-205,
Code No.: 001-025-790)
CB-05BFFM (φ10)
Use the optional gasket. (Type: OP03-206,
Code No.: 001-035-290)
This height should be lower than the
RF unit when installed to the bottom
of the sensor.
Cable
Gasket
22
A
view
NMEA cable
RF unit