Wiring Inside Drs2D/4D - Furuno DRS2D Installation Manual

2.1

Wiring inside DRS2D/4D

Two-way cable connection
1. Unfasten three screws at the bottom of the mounting base to remove the fixing plate for the
gasket.
2. Remove the gasket, and pass the two-way cable MOD-ASW0001.
3. Fasten the shield of the cable (power) with the cable clamp in the radar sensor, and connect
the connector of cable (power) to the power terminal.
4. Connect the RJ-45 connector of the cable (LAN) to the LAN terminal in the radar sensor.
LAN terminal
5. Push cables of the two-way cable into the slits of the gasket inside the radar sensor.
Note: The ends of the gasket are different. Larger end should be up.
Fix the cable (LAN)
with this locking saddle.
Large
Small
Fixing plate
(for gasket)
Power terminal
Fix the shield cable
(power) with this clamp.
Up
15