Furuno DRS2D Installation Manual page 12

2. Lay the radar sensor on the mounting platform, orienting it as shown below. (The hinges must
face toward the stern.)
3. Insert four hex bolts (M12 x 60, supplied) and seal washers (φ30, supplied) from the top of the
housing, as shown below.
STERN
Hinge
CAUTION
Do not lift the radar sensor by the
radiator; lift it by the housing.
The radiator may be damaged.
BOW
Hex. bolt
Seal washer
(Face projecting part down.)
Flat washer
Spring washer
Nut
5