Nokia RM-313 Service Manual page 78

iii Choose the product manually from File→Open Product , and click OK.
Wait for the phone type designator (e.g. "RM-1" ) to be displayed in the status bar.
iv Go to Flashing→Firmware Update and wait until
following picture.
Product is automatically set according to the phone support module which was opened manually,
but the flash files cannot be found because the correct data cannot be read from the phone
automatically.
Code must be chosen manually, it determines the correct flash files to be used. Please choose the
correct product code (can be seen in the phone type label) from the dropdown list.
Flash Type must be set to Phone as Manufactured.
v To continue, click Start.
Progress bars and messages on the screen show actions during phone programming, please wait.
Page 3 –26 COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
BB Troubleshooting and Tuning Guide
Phoenix reads the product data as shown in the
RM-313
Issue 1