Page of 208
Download Table of ContentsContents Print This PagePrint Bookmark

Nokia RM-313 Service Manual: Transmitter Troubleshooting

Hide thumbs
RM-313
RF troubleshooting
• Mode: RSSI
• Continuous mode
6. Click Start to perform the measurement.
Results
The reading should reflect the level of the signal generator (-losses) ± 5 dB.

Transmitter troubleshooting

General instructions for transmitter (TX) troubleshooting
Please note the following before performing transmitter tests:
• TX troubleshooting requires TX operation.
• Do not transmit on frequencies that are in use!
• The transmitter can be controlled in local mode for diagnostic purposes.
• The most useful Phoenix tool for GSM transmitter testing is "RF Controls"; in WCDMA transmitter testing
the best tool is "TX Control".
• Remember that re-tuning is not a fix! Phones are tuned correctly in production
Note:
Never activate the GSM or WCDMA transmitter without a proper antenna load. Always connect
a 50 Ω load to the RF connector (antenna, RF-measurement equipment or at least a 2 W dummy
load); otherwise the GSM or WCDMA Power amplifier (PA) may be damaged.
GSM transmitter troubleshooting
Steps
1. Set the phone to local mode.
2. Activate RF controls in Phoenix (Testing→GSM→Rf Controls ).
Make settings as shown in the picture:
Issue 1
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
Page 4 –13

This manual also for:

N82, L3, L4

Comments to this Manuals

Symbols: 0
Latest comments:
  • Pavel Kraemer Dec 31, 2016 03:20:
    I cannot find how to switch off front flash on NOKIA 230.
    Pleas​e inform to
    pkraemer@​volny.cz