Table of Contents
Advertisement
Fan Power Connectors:CPUFAN/SYSFAN
The CPUFAN (processor fan), SYSFAN (system fan) support system cool
-ing fan with +12V.It supports three-pin head connector. When connecting the
wire to the connectors, always take note that the red wire is the positive and
should be connected to the +12V, the black wire is Ground and should be
connected to GND. If the mainboard has a System Hardware Monitor chipset
on-board, you must use a specially designed fan with speed sensor to take
advantage of the CPU fan control.
CPU FAN and SYS FAN
CPU FAN and SYS FAN
CPU FAN and SYS FAN
CPU FAN and SYS FAN
CPU FAN and SYS FAN
WOL1: Wake On LAN
If you have installed a external LAN card, use the cable provied with the
card to plug into the mainboard WOL connector. This enables ables the Wake
On LAN(WOL) feature. When your system is in a power-saving mode, any LAN
signal automatically resumes the system.You must enable this item using the
Power Mannagement page of the Setup Utility.
This Manual: http://www.manuallib.com/file/2414879
PIN
Assignment
1
FAN speed detect
2
+12V
3
GND
FAN1-CPUFAN
1
FAN2-SYSFAN
WOL1
1
Connectors
27
27
27
27
27
Advertisement
Table of Contents
